Convertibars Yamaha: FZ1(00-05) Instrukcja Użytkownika Pobierz pdf

Yamaha FZ1(00-05)

Bike Specific Install Notes and Tips

This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to

set up components and to route lines in the ?best way possible?, which may not always be listed on this ?Bike

Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with

out pulling taught or kinking any lines, and without damaging any part of the motorcycle

Important Installation Considerations

6.5 inch tall handlebars do not require longer lines.

Restrictions

1. Foreword Positions restricted by instrument panel

2. Fairing side pieces or intake ducts interfere with the riser when rotating the

Cyclops Clamps. Raising the handlebar so the riser is above the fairing side

pieces before rotating the Cyclops clamps will solve this restriction. Trimming

the fairing side pieces could also increase convertibility.

Recommended Riser Trim Length

1. 6.5" Riser Length = Trim Number 11

Recommended parts and replacement lines

1. Longer lines than stated here may be required if raising the bars more than the

recommended trim length.

2. Hydraulic Clutch Line Top Fitting - 90 degree face to the side

Yamaha FZ1(00-05) Bike Specific Install Notes and TipsThis is an aftermarket product that fits up different than the stock components, therefore, the

Brak uwag

Convertibars Yamaha: FZ1(00-05) Instrukcja Użytkownika